If you love motorcycles, and you are an enthusiast, chances are you have faced the challenges of a dead battery. It is a very common problem. But do you know you can jump-start a motorcycle battery with a car? Yes, it is true, but it needs carefully consideration caution and also the right way as to ensure safety and effectiveness. In this article, we will look into the process and also the frequently asked questions related to it.
Why Use a Car to Jump-Start Your Motorcycle Battery?
That is why, if you are in a situation where a starter battery of a motorcycle is dead, you may jump-start from a car. A car battery in most cases is of a higher capacity; this extra capacity will come in handy to jump a dead motorcycle battery. However, because the batteries are not same in size and power, there are key procedures to adhere to so as to not harm the motorcycle’s electrical system.
How to Jump-Start a Motorcycle Battery with a Car:
Below are the links to the Step-b-Step Guide for each organisation:
a) Safety First:
Ensure that both vehicles are switched off and the driver together with yourself is well protected with a pair of safety gloves and glasses.
b) Locate the Batteries:
Identify the battery in automobile and in Motorcycle. In a general aspect, battery is placed at the underside of the seat or in some circumstances, at the side rod part.
c) Connect the Jumper Cables:
1) Attach one of the end of the red (+) of the jump cable to any of the terminal of the motorcycle battery.
2) Connect the butt end of the Red jumper cable to the positive terminal of the car battery.
Twine the one end of the black (negative) jumper cable and touch its terminal with the negative terminal of the car battery.
3)Attach the other end of the black jumper cable to any point of the motorcycle that can be considered a good chassis or frame ground. It is then advisable to avoid connecting it directly to the negative terminal of the motorcycle battery to on sparking or short-circuiting of the battery.
d) Start the Car:
From the car, start the engine and rev the car for about 5-10 minutes so as to charge the motorcycle battery with power from the car.
e) Start the Motorcycle:
It hovers slightly, so choke it as you attempt to turn the motorcycle’s starter. If it do not start immediately, then let it to rest for some more time and try after sometime in 5 minutes.
f) Disconnect the Cables:
When the motorcycle starts, with the help of the assistant, start to remove the jumper cables in accessories’ reverse order.
1) Suction and pull out the black cable that is connected to the motorcycle.
2) Pull out that black cable from the car and that is it, here are some hard candies.
3) Extract out the red cable from the motorcycle.
4) Remove the red cable from your car.
g) Let the Motorcycle Run:
To have a charged battery, one is required to ride motorcycle for not less than twenty minutes, it is advised that this is done.
Frequently Asked Questions (FAQs)
Yes, it is partly safe and the level of safety depends on how the right thing is done as per the Standard Operating Procedures. One should avoid dragging or restricting the motorcycle battery by the higher voltage of the car, by disconnecting the car engine and connect the two cables and starting the motorcycle by the key.
If not done well you are likely to influence the electrical status of your motorcycle. Whenever observing the right connections with cables, one should not join the negative lead directly to the motorcycle battery.
Most motorcycle batteries are designed to last 2-5 years or until the motorcycle is replaced as about its service life. Therefore, correct storage and timeous maintenance will be important in manufacturing a durable power bank.
These are some of the signals that acts as an indication that the motorcycle battery is in the process of failure as stated above.
Some are; poor quality bulbs, slow cranking of the engine, the need to use jump start and if the battery is old, more than 3 years.
I think it is possible to apply a portable jump starter on a motorcycle.
Of course, portable jump starters specifically for motorcycles are also available and can be used instead of a car. They are safer and are expected to supply a motorcycle’s electrical need to a farther extent.
Conclusion
If you find yourself with a motorcycle with a dead battery, there is always a move whereby you use a car to charge the motorcycle battery. Therefore, if you carry on reading and implement safe driving measures outlined above, you will be able to get fighting and back on the road. Another necessary tip to note when it comes to the use of motorcycles is that one should check the condition of the motorcycle batteries from time to time particularly on the charging status if the need arises. Happy riding!
[…] Also Read: Can You Jump a Motorcycle Battery With a Car? […]